Common problems and solutions for cable box installation

Common problem:

1. Blockage of the wire hole affects wire feeding and winding.

2. The four corners of the distribution rack are prone to wire entanglement, resulting in broken wires or maintenance downtime. 

Solution:

1. Observe irregularly, clean the dust and waste from the wire holes, and insist on clearing the wire holes.

2. When winding the wire on the distribution rack, the enameled wire should be placed in the best position.

Common problems and solutions for twisted wire groups

Common problem:

1. The loose Fried Dough Twists of twisted wire affects the failure of winding.

2. Twisted Fried Dough Twists wire is too long or too short to produce Fried Dough Twists wire or loose wire products.

3. The twisted wire motor does not operate or the motor operates but does not twist the wire.

Solution:

1. Adjust the flexibility of the twisted wire clamp and adjust the groove position of the Youli adhesive.

2. Adjust the balance of the tension spring force and adjust the position of the pressure line group's adhesive.

3. Check if the power plug is loose or has poor contact. If the motor is operating without twisting the wire, check if the rotating shaft screw inside the motor is loose or stuck.