Main performance characteristics

1. Adopt the "Three Guarantees" structure to reduce dust and make it more environmental friendly;

2. Man machine interface control and operation control are convenient;

3. There are many ways to control the descent of the catheter: length, time and positioning sensor, with accurate descent position;

4. Pneumatic clamp is used to load and unload materials manually;

5. The dropping time can be controlled to reduce the waste of magnesium powder;

6. The ejector can be selected to prevent the ejector from bending;

7. The lower part is fixed by numerical control, which is convenient and labor-saving;

8. The guide chain is distributed on both sides, the tension is uniform, and the sliding seat bearing is more durable;

9. Equipment workflow monitoring;

10. Equipment fault prompt;

11. Data monitoring of main time of each action of equipment;

12. PLC I / o point monitoring;

Main technical parameters

1. Power supply: single phase 220 V / 50 Hz, 1.5 kW

2. Gas source: 0.5 ～ 0.7MPa

3. Processing pipe diameter: φ 8 ~ φ 13 (customized)

4. Processing length: (the following are common models and customized for other models)

5. Quantity of each processing (number of jobs): 30 ~ 36 pieces (determined by pipe diameter, customized according to demand)

6. Rising speed of powder filling: 300 ~ 350mm / min (variable frequency adjustable)

7. Filling density: ≥ 2.25/cm3

8. Mandrel drive mode (wire drawing up): cylinder drive

9. Conduit driving mode (conduit rising and falling): variable frequency motor

10. Protection mode: single catheter

11. Control mode: man machine interface

12. Production efficiency: about 7000 / 8 hours (calculated by 36 stations of 300 mm)