Main performance characteristics

1. Man machine interface control and operation control are convenient;

2. Pneumatic clamp is used to load and unload materials manually;

3. There are many ways to control the descending of catheter: the length, time and descending position are accurate;

4. Two program choices: the lower part can be clamped or not clamped;

5. The dropping time and the depth of the dropping pipe can be controlled to reduce the waste of magnesium powder;

6. When filling powder, the pipe rises slowly to prevent the nozzle from leaving before the magnesium powder reaches the bottom of the pipe;

7. The ejector can be selected to prevent the ejector from bending;

8. Following oscillation (this function is only for following random);

8. Equipment workflow monitoring;

9. Equipment fault prompt;

10. Data monitoring of main time of each action of equipment;

11. PLC I / o point monitoring;

Main technical parameters

1. Power supply: single phase 220 V / 50 Hz, 2.5 kW

2. Gas source: 0.5 ～ 0.7MPa

3. Processing pipe diameter: φ 8 ~ φ 13 (customized)

4. Processing length: (the following are common models and customized for other models)

5. Quantity of each processing (number of jobs): 30 ~ 36 pieces (determined by pipe diameter, customized according to demand)

6. Rising speed of powder filling: 300 ~ 350mm / min (variable frequency adjustable)

7. Filling density: ≥ 2.25/cm3

8. Mandrel driving mode (wire drawing up): variable frequency motor

9. Conduit driving mode (conduit rising and falling): variable frequency motor

10. Medium protection mode: three tubes (four wing nozzle, powder nozzle, three medium protection)

11. Control mode: man machine interface

12. Production efficiency: about 4500 / 8 hours (calculated by 36 stations and 300 mm)